WALL PAINTING WITH BLOCK BİMS PRODUCTS

Since the products are interlocked, vertical mortar is not used. Only 10 mm of mortar mortar is used in the horizontal. If the special BLOKBIMS-Y adhesive mortar is used, this thickness is between 4 and 6 mm. The lower the thickness of the mortar means the reduction of the heat bridge. In this context, it is recommended to use 0-3 mm bims aggregate when normal mortar application is desired.

---

CUTTING:

Half the products are shipped as standard in the shipment; half of the products are used in the beginning of the wall row. In this case, the products can be cut to any desired size.

---

CHANNEL OPENING:

When it is desired to install electrical or water piping from the completed wall surface: the places where the installation is to be carried out again a) the lumberjack and b) spralle c) It can be opened easily with grooving machines and does not cause any wall loss, only the places where it is desired to open.

---

PIPING:

Gypsum plaster can be applied directly to the finished wall surfaces without spreading plaster and rough plaster. The surface penetration of BLOKBIMS is very good and since it is a cement based product, it has excellent adhesion. Does not shrink after plaster, does not make plaster.

---

SCREW and MECHANICAL ANCHORAGE APPLICATIONS:

The wall surface can be opened with any kind of electric drill and the hole can be opened easily.

---

SOUND INSULATION:

BLOKBIMS with a thickness of 10 cm has a sound measured sound insulation value of 40 db. This shows that Sound insulation is the best among the natural building products.

---